1 / 6
Better X axis belt carriage for Neptune 4 — image 1
1 / 6

Better X axis belt carriage for Neptune 4

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Small belt clamp that fixes the cosine error of the stock attachement and also doens't pinch the belt

Rating
5 / 5
Likes
36
Downloads
133
Makes
6
Views
973
Reviews
5

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Improved belt attachement for the printhead, fixes cosine error by having the belt inside the extrusion, and doens't pinch the belt like the stock mount. There is a screwhole to help keep it in place if it comes loose. It works with the complete Neptune 3/4 lineup.

 

Installation 

For N3,N4,N4 + and  N4 Max (v3):

Start by splitting the print in half. Replace the original belt and loosen both top pom wheels to remove the carriage. Put the belts inside the bracket and clamp them to the approximante length to be the same width as the carriage. Once that is done slide the clamps onto the carriage, Push the printhead in place and put the pom wheels back on. The excentric nuts on the bottom side may interfere during installation, but turning them leaves enough room. 

For N3,N4,N4 + and  N4 Max (v2):

Start by splitting the print in half and removing the rest of the bridge in between the parts. Replace the original belt and loosen both top pom wheels to remove the carriage, then slide the clamps onto the carriage and insert the belt. Ppush the printhead in place and put the pom wheels back on. The excentric nuts on the bottom side may interfere during installation, but turning them leaves enough room. 

For N4 Pro:

Start by splitting the print in half and removing the rest of the bridge in between the parts. Then remove the stock belt, and remove the bottom Sg15 rollers with the excentric nut. After that you should be able to unscrew the bottom part of the carriage and install the clamps like on the picture. Now route your new belt around the pulleys and insert it, if it is too long you don't necessarily have to cut it as there is some spare room. Once the belt is inplace with no tension and little slack you can screw the carriage back in.

 

To use this mod you will need a slightly longer belt:

  • Neptune 4 Base/Pro/Plus 1m

  • Neptune 4 Max 2m

Recommended belt: Gates 2gt epdm 6mm (affiliated)

 

Print settings:

import as single part and print like oriented.

  • No supports necessary

  • make sure the bridge orientation is like in the picture above

Recommended material: Low creep high impact resistance, rigidity.

  • ABS / ASA 

  • PETG

Not recommended: PLA as the printhead sits close to the heated bed the heat will weaken the PLA and will just creep.

 

(White PLA, Pink PETG) Both printed within a day and under 40N for ~3 months

  • V2 fixed the alignment of the belt

  • V3 New stronger design

Submit feature requests here!

Tags