Prusa GPIO Hackerboard Timelapse Cover | Smartphone
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.28 – €1.56 net (excluding VAT)
For file: Timelapse Cover_L_0.4n_0.2mm_PETG_MK4S_1h1m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.42 excluding VAT (range midpoint).
- Weight reported by the author
- 28 g
- Print time reported by the author
- 1.02 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a cover to house a bluetooth remote trigger with a Solid State Relay (SSR) to use with your smartphone.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 9
- Makes
- 0
- Views
- 419
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a minimalistic cover to house a bluetooth remote trigger and a Solid State Relay (SSR) to create beautiful timelapses with your smartphone.
Fuction:
The GIPO Board sends a signal to the relay which then simulates the button press on the bluetooth remote trigger.
What do you need?
- Bluetooth Remote Trigger like this or this this.
- Solid State Relais
- 2x Wago Connector for 3 units
- Barrel connector (only female; it needs to fit the powersupply)
- 3V Powersupply with barrel connector fitting the female part
- 2,5 mm to 3,5 mm Jack connector
- 3,5 mm Jack cable
- 3V Powersupply
- Some wires
- 2x M3x12 socket screw
- Optional: M3 T-Slot Nut for 30x30 aluminium extrusions or print the M3 T-Slot Nut from the part list and insert a hexagon nut (based on this)
- And ofc the GPIO Hackerboard
Print instruction:
- PETG or another material if used near the printer
- No support needed
- There is one version for the left and one for the right side of the printer
Build instruction:
- First find out which 2 of the 4 pins of the button you have to solder a wire to in order to make a photo
- Position the electronics into the cover and estimate the cable lengthes.
- Wire all the cables
- Connect the GPIO Board with the 3,5 mm jack to the input of the SSR
- Connect the trigger with the SSR
- Powersupply for the bluetooth remote device and the SSR
- Solder the barrel connector for the powersupply - Check if everything is working
- Add the electronics to the cover. It should look like this but depends on the orientation Left or Right Version
