Smarty 13 Head for Dummy 13 x500

This is designed to accept a Waveshare 1.28" round display. They have 3 models that fit, an ESP-32S3 processor , one with a rp2040 processor, or a simple SPI display to connect to a Arduino, Raspberry pi etc. There are some openings to route wires out the back of the head. The Ball clamp makes it easy to pose and hold position much easier than the original head, but is compatible with the original neck at 500% size. If you want a smaller than 500% you can replace the display with a translucent round lens and put an RGB led behind it. Lots of videos on Youtube for programming the Waveshare display. I am planning on programming some eye graphics, but that will be in Feb or March probably. Just finished the 3d model. The Face piece has two 4mm holes to accept Ruthex M3x5.7 inserts for 2 3mm x 4mm screws. These are for the display clamps. Feedback or questions can be made here -→ https://www.patreon.com/posts/121151212