Valentine's Heart Treat Container
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€4.41 – €5.39 net (excluding VAT)
For file: Valentine's Heart Treat Container Bottom_1Color_0.2mm_PLA_MK3S_4h52m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €4.90 excluding VAT (range midpoint).
- Weight reported by the author
- 62 g
- Print time reported by the author
- 4.87 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a two piece, press-fit, lidded container in the shape of a heart. Fill it with sweets.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 13
- Makes
- 0
- Views
- 103
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Spring & Easter
- License
- Creative Commons — Attribution — Noncommercial
This is a Valentine's Day treat container you can refill and use again and again. Or you can gift it to someone special. Why buy overpriced, pre-filled hearts when you can buy good candy and fill this one completely full?
Since love can be irrational, I increased the size of each heart iterratively by the golden ratio (Phi). This model was designed using TinkerCAD code blocks.
I revised this model a few times, but to get the right amount of press for the press fit, you will want to press the lid in and pull it out repeatedly to get it perfectly tight but not too loose. You could also sand it gently, but don't be too aggressive because the lid will get too loose.
The original model will typically fit your candy well enough, but there is a tall version of the bottom for larger candy (like truffles) that will not fit in the original model.
You need:
- top x1
- bottom x1 (pick original or tall)
The stl files may need to be sliced so you can print it on your printer. My printer is a single nozzle, PrusaMK3s. I have provided Gcode for my printer, and I added stop points to the Gcode so you can swap the filament during color changes.
Feel free to remix my model. If you print it, share some pictures. I want to see them!