Power Supply Wall Mount Bracket
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.28 – €2.79 net (excluding VAT)
For file: Power-Supply-Bracket-1-piece-2h18m-13.20m-.46-PET_G.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.53 excluding VAT (range midpoint).
- Weight reported by the author
- 39 g
- Print time reported by the author
- 2.31 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This bracket will fit the original power supply that came with the Prusa MK3
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 18
- Makes
- 0
- Views
- 121
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I created this model for my power supply that came with my Prusa MK3. I needed to mount off the face of the mount plate, so I built in standoffs in the bracket. I printed these on their side so to reduce the amount of supports needed.
- The G Code file only prints one part, but you require two of these brackets.
- I printed these in PETG. They need to flex open to put the power supply in and then clamp on the power supply.
Model
You can get the parametric FreeCAD model here.