Garmin Zumo XT2 adjustable table stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Table stand for your GPS navigator, adjustable angle. Can be used in car as well.
- Rating
- 5 / 5
- Likes
- 2
- Downloads
- 33
- Makes
- 1
- Views
- 212
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
Table stand with adjustable angle. Can be used on table or if you put some rubber on it you can use it on car dashboard as well, and then you can use an angled cable. See pic below.
Three different parts to print:
Additional hardware needed:
- Bolt M6x50 mm, hex head or regular
- Washer
- Nut (or wing nut)
- 2x screw 2.5x5-8 mm or such
You can use hex head and wing nut with the larger joint, or you can use a regular bolt and nut with the smaller joint, you choose.
If you put rubber pads on it stands better, no gliding around and also it makes it possible to use an angled USB cable!
Print instructions:
Base: Paint on organic support on top overhang.
Joint: On hex version paint on snug support in hex head area.
Leg: Paint on or build plate only on the curvature to the sheet.
Everything needed is already prepared in 3MF's:
Change notes:
I noticed it might fall over if you have it on your dashboard and accelerate hard. So I made a more stable version which extends in front. Which version you choose is up to usage I think:
If you like my work, consider buying me a coffee:
https://ko-fi.com/maildannesholkse
Check out other Garmin prints in the collection:
https://www.printables.com/@BentDerailleur/collections/2063450
