Case for Raspberry pi 5 with fan and official NVME HAT with SSD
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I couldn't find any cases for the Raspberry Pi 5 + NVME SSD HAT. So I made one. I added hexagons for vent holes because.
- Rating
- 0 / 5
- Likes
- 23
- Downloads
- 226
- Makes
- 0
- Views
- 1,196
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
If you downloaded this before 2/5/2025 download the lid again. The end with the USB and ethernet had more gap than intended. It's fixed now.
This case has recesses on the bottom to screw the risers for the NVME hat in through the case and board so it is secure. My first revision I didn't have any vent holes on the side of the case. The lid just sits in place and doesn't have any fasteners or anything which is just fine for me. I may change that or modify this case in the future. Iunno. Meh.
I print with brim and supports everywhere. You might be able to get by without it. Your mileage may vary, batteries not included, no COD.
Comment if you want the Freecad file but be forewarned, I have no idea what I'm doing and my design reflects that.
I'll add a pic of the base with the vent holes later.