Box for drying silica gel on a printer bed
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Box for drying your silica gel on a printer bed at 105 °C
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 40
- Makes
- 0
- Views
- 401
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
Print it out of PC Blend is MUST due to high drying temperature. Layer 0.2 mm. Use 10 mm brim and apply glue at PEI sheet.
Drying procedure : Fill box with layer about 1 cm high and put it to the middle of your printer bed and heat it to 105°C and dry for 1,5 hours. Some printers will stop heating after 30 minutes so start it again twice. After it cools down to room temperature immediately fit cover and “pour” it whenever your store dry silica gel or directly to container for filament spool as my favourite : https://www.printables.com/model/65922-silica-gel-spool-container