3mf File from Bambu Studio For "FUNKO POP DISPLAY SHELF" by KBartels
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I added blockers to parts of the shelves to allow funkos that come in packs of 4
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 54
- Makes
- 0
- Views
- 588
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
-3mf file made in Bambu Studio of original model.
-Multiple plates with the whole shelf, blank shelf, and left and right pieces made by adding negative objects to act as blockers.
-I know this opens in Anycubic slicer however I have not printed using it as I use Bambulabs, for this reason I assume it will work in Orca, ensure you have correct settings and Start/End gcodes before printing :)
-Between the left and right shelving you will require the blank shelf in-between, both above and below the middle of the two shelves as the 4 pack would interfere with normal shelves in those spots.
-Due to the orientation of the individual shelf pieces, you will also not fit a funko underneath both the left and right models.
-Total of 4 slots taken up by installing a x4 funko so I recommend doing it at the bottom of your shelving.
-If you are using the specific shelves with blockers you will need to orient the shelf as shown in the pictures, when you do this it will be almost impossible to insert the connectors going from the sides to the column of shelves either side of the left and right pieces for the x4 inserts so I only put the connectors in top and bottom for these pieces.