Logitech StreamCam Infill Cover
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.87 – €1.06 net (excluding VAT)
For file: 22.01_StreamCamLid.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.97 excluding VAT (range midpoint).
- Weight reported by the author
- 11 g
- Print time reported by the author
- 1.02 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a remix of an existing cover design for the Logitech StreamCam by Dolmaster.
- Rating
- 4.875 / 5
- Likes
- 43
- Downloads
- 214
- Makes
- 9
- Views
- 932
- Reviews
- 8
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This remix has an obvious and a few less apparent design changes.
The most obvious change is that i opened up most of the cover area by removing the top an bottom layers and thus revealing the infill.
(I needed to do some geometry trickery to compensate for Elephant foot compensation)
This has a few advantages:
- the microphone works perfectly well while the camera is covered
- it wastes less material
- you can customise its look easily just by changing the infill type and density
- it looks cool imo
I also changed some clearances and added a simple locking system that locks in place if you let it fall down and is easily opened.
For the hinge you still just need ~35mm of 1.75mm filament, which was part of the original design.