CYMA MP5 Grip with standalone foregrip.

This is a handguard for MP5 CYMA model inspired by MP5K and Romanian grips. 

Huge thanks to @michalgerhat for creating a basic handguard that i used as my canva and to https://makerworld.com/en/@SJHCreate that created the foregrip.

All i did was combine these two elements into one using blender software.

This way i created the handguard i wanted initially, thanks again!

It's comfy, im 180 cm height, so hands are not too far nor too close. You can still grip it on handguard itself a little closer too.

NOTE: Pin holes might not perfectly align, i used soldering tool to widen this hole, you might not encounter this, but just letting know.

Used 0.25 resolution and 35% infill, 4 walls (not necessary, it just happened to be set up for me). Tree supports were most economic, use them. Print time around 8-9 hours. Print vertically, this way you will achieve best durability.

Good size battery fits inside, only slightly smaller than stock handguard.

Grip is hollow, i didn't edit this intentionally, thought that it could be used for something later on, electronics perhaps.

If needed, i can edit the model and post more files, just let me know.