Kingdom Death Ultimate Showdown Board Priming/Painting Helper
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A tile holding jig for spray-priming the showdown board for KD:M. Keeps the tiles still and open for paint.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 46
- Makes
- 0
- Views
- 700
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Miniature Gaming Accessories
- License
- Creative Commons — Attribution — Noncommercial
Spray priming the Ultimate Showdown Board looked like a nightmare, with the small tiles flying around in the wind or under the force of the spray paint. I designed this set of helpers to hold the tiles in place so they could be primed more easily.
Holds each tile from beneath, only on unseen/unpainted surfaces, leaving space around each tile for the spray to get between them. I've designed the three supplied models to support different bed sizes depending on what you have available.
The Single-Row variant will handle one row of tiles from 1-22 (actually 23 spots for symmetry) and is 228x228mm
The Two-Row variant handles two full rows (again with a couple extra spots) but requires a much larger bed, it is 328x328mm
For those with smaller printers, a single 16-tile column holder can be printed that only takes up 168x148mm bed space. For this one, I reduced the inter-tile spacing somewhat to fit below 200mm^2.
The openScad design is also supplied for those who wish to tweak before printing.
No supports needed, but the far corners have a habit of warping in ABS, so print with PLA or similar