10inch modular rack
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Expandable modular block 10in Rail System, with Euro rack rails for audio equipment. Prints on 256x256mm bed
- Rating
- 0 / 5
- Likes
- 82
- Downloads
- 226
- Makes
- 1
- Views
- 2,710
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Share Alike
A modular, expandable 10in rack system.
Can be expanded to take 19in equipment, and will also accept euro-rack modules
I'm adding new features daily, so please keep checking back.
If you like this model, please consider buying me a coffee:
Each block is 1u in height.
I've made each piece so it will fit on a 256x256 (10in) build plate.
The blocks take m6 nuts - hex are a tight fit, square a loose fit. The holes are 6mm diameter, so will take a m4 heatset insert if you prefer
The ends of the side plates, and “slides” (drawer slides) have holes to take a m3 heatset insert
The 2020 crossrail has 2x slots for m3 square nuts for eurorack modules and also a 2020 compatible slot to allow top+bottom plates to be added to the outside of the case.
The Euro Rail has a single slot for eurorack modules faceplates and is thinner to allow a little more room between the rails for components
-------
NOW ADDED:
Double Block
To make a double wide rack
19in Adaptor Block
Use 19in rack equipment in a “double wide” 10in rack
Centre Nut.
This will slide into the vertical nutslots on the 1u blocks, to provide a spacer between the top and bottom square nuts. It has a m6 thread for the central bolt hole.
It ONLY works with square nuts.
-
Drawer Slides.
The drawer slides can be attached by m6 bolts - use 30mm long at the back, 35mm at the front to act as a stop pin (if required).
-
Multiboard top/bottom plate.
A solid plate which mounts between the uprights with 4of m6x35 bolts and square nuts (hex will also work, I think)
Takes a 8x8 multiboard tile, fastens with a “big thread” at each corner, and/or a M6 screw at the centre.
I use the top to mount a 10" screen for a HP elitedesk800 g3 which fits nicely on the shelf
-
Top/Bottom Plates.
or shelves.
I've added these to allow a m6 threaded rod to pass all the way through - it adds a lot of strength to a “double wide” rack.
Various designs, some with m6 threaded holes on 25mm spacing, one to take a 8x6 multiboard tile.
-------------------
A design based off Chris Borge's modular block idea for his ten inch rack:
https://www.youtube.com/watch?v=phtN679qpEM&t=64s
I wanted to build a rack using the design in the above video, but at the time of releasing this model, there were no files available, so I made a “best guess”.
Watch his video for an idea of how it's used.