Dawn Twister Bottle Brush Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I did not have a good place for the bottle brush in my work kitchenette, so I designed this stand.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 16
- Makes
- 0
- Views
- 77
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
We have a little kitchenette at my office, but it sorely lacks places for storing sponges, rags, brushes. . . so I designed this stand so the bottle brush would not have to hang over the edge of the sink to dry.
When I sliced it, I added a few solid layers at about 2.25in / 60mm and used a 15% grid infill for the entire thing. Then I added steel shot and epoxy to weigh the base down and keep it from tipping over. You can use sand, and it will work the same, just a bit lighter.
Then I added a layer of 1/8in / 3mm adhesive backed neoprene foam to the bottom of it to keep it from sliding around.
This is the bottle brush I designed the stand for. There may be others it works with.
https://www.dawnkitchen.com/dawn-twister-bottle-brush.html