1 / 3
Kite Reel Winder - REMIX - Replacement PiP knob, and a lock gadget. — image 1
1 / 3

Kite Reel Winder - REMIX - Replacement PiP knob, and a lock gadget.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replaced knob with Print-In-Place one with rotating collar. Added a way to lock the kite line.

Rating
0 / 5
Likes
11
Downloads
40
Makes
0
Views
324
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Lovely original design - get all the other parts from the linked original. I also gave the bolt sizes (difficult to read in the diagrams there) and my assembly instructions in the “Make” comments there. 

In the original, Part5 is the winding knob. Print in the orientation supplied (knob upwards). No supports or adhesion. I used 0.2mm layers with a 0.4mm nozzle. The collar will probably be VERY well stuck to the shaft! Grab the collar with a rag and pliers or a silicone gripper sheet if you have strong hands, and give it a good twist. Once it's free, and you've given it a few firm turns back and forth it should be running freely.

The clip is in two parts, join them with an M3x8 bolt. The main body's bolt hole size is designed for self-tapping - it will be VERY TIGHT after the first slightly looser guide part of the hole. Tighten it until the swivel clip is snug enough to hold its position so it doesn't just waggle around. The swivel part clicks into place on the receiving rod end. The click action isn't load-bearing, it's just there to ensure that the locking pin doesn't slip out of the winder hole.  

If you have a lot of line on the reel it might not be possible to fit this clip, but I expect when a good half of the line has been released, the winder holes will be exposed sufficiently to get the little lock rod through them.

Hope these extras are useful :o)