1 / 6
ZOHD Altus DJI 03 Air Unit Nosecone Mount — image 1
1 / 6

ZOHD Altus DJI 03 Air Unit Nosecone Mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix of DJI 03 Air mount for ZOHD Altus nosecone that is smaller, lighter, stronger, easier fitting, more ergonomic.

Rating
0 / 5
Likes
2
Downloads
64
Makes
0
Views
273
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Assembly instructions:

  1. Tap M3 threads into holes into fan mount holes on lid or use self-tapping screws M3 * 14mm to secure 30 x 30 x 10 5Vdc fan to lid.
  2. Secure FAN to lid.
  3. Tap M3 threads into receiver holes on base for the lid or use self-tapping crews M3 * 10mm and force tap M1 threads into base to nosecone holes or use self-tapping screws M1 4/5 mm.
  4. Install DJI 03 Air unit by sliding into base receiver slot, note position/orientation of USB and micro-USB-C port.
  5.  Secure the lid and fan sub-assembly to the base.
  6. run DJI Antenna cables through slot and push antenna plastic stem through the 4mm recess (note it should fit snugly without the need to glue or cable tie).
  7. Plan the DJI 03 air unit to camera run and exit fan power and DJI 03 Air unit VTX SBUS cable when positioning mount into nosecone recess.
  8. Position the base to nosecone holes and screw the mount down.
  9. Run the cables to suit your specific receiver connections. If using SpeedyBee F405 WING, the provided DJI SBUS VTX cable is long enough to reach the FC if it is center to CG in the body.

Tags