Two Table Saw Push Sticks (1/4 Inch and 1 Inch Blade Clearance)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Both of these push sticks are designed to help safely move lumber through a table saw and work well in PLA.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 48
- Makes
- 0
- Views
- 254
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
These two table saw push sticks are designed to save you from ordering plastic junk online.
The 1 inch clearance stick can push a ½ inch or taller piece of material through the saw and it can be flipped over to use the “unicorn horn” if something gets stuck. The angle for both sides is pretty useful, but if you are printing in PLA it's important to remember that these can't take a ton of force.
The ¼ inch clearance stick is helpful for thin material (¼ inch height or taller) and it has three handles for transferring the material passed the blade. This tool also has built in tracer lines in the middle for 90 and 45 degree marks so it doubles as a basic protractor. Again PLA isn't incredibly strong, but it should be sufficient enough if you don't crank on it.
Printing instructions: The 1 inch stick should be printed with the side that contacts the table flat on the build platform and then you'll need to rotate it about 50 degreed to make it fit. The image in this post shows the orientation - it's a tight fit. I used 0.25mm STRUCTURAL with 10% Gyroid infill with a brim and supports everywhere. The ¼ inch stick can be printed flat directly on the build platform - I used 0.20mm STRUCTURAL with 15% Gyroid infill.