1 / 4
Arendo mixer, chamber outside reinforcement
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For a 2kw Arendo mixer: stronger! Where the chamber has most stress, apply pressure and minimise cracks or breaking
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 32
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- GNU General Public License v2.0
Also check out this lid reinforcement
Print settings:
- 6 to 8 perimeters, ≥6 top layers and ≥6 bottom layers
- In the pictures it's PLA for stiffness, but PETG might be better
- Supports: only needed on the platforms the screws rest on: use paint-on supports and use “tool type: smart fill” to just click 2 times (after having rotated the view so you see the part from below).
- Then just “+” add instance to print 4pcs in total, the supports settings will automatically duplicate
Assembly:
- Use M6x50mm screws, washers and nuts (preferrably locknuts) to assemble them together; Slide the nuts into the hexagonal holes, no need to push them all the way down.
- Then place the parts on the mixer and screw two together: the screw will pull the nut all the way down.
- Do not tighten fully, repeat on all 4 corners, then tighten in an X pattern.
- The parts should still leave about 0.5-0.1mm clearance between each other on the chamber corner. Do not tighten the screws all the way to 0mm clearance, you may risk breaking the mixer chamber or the parts.
I use this mixer for grinding plastic to recycle 3d prints and it has been working great even though it was not designed for that. Hence these reinforcement parts