ERCF v2 Filament Block with builtin pre-gate sensor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A filament block from ERCF v2 redesigned to have a builtin pre-gate sensor
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 98
- Makes
- 1
- Views
- 803
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Standard block from ERCF v2 (aka Triple Decky C7) with a sensor.
Requires a 4mm ball bearing and a D2F-01FL endstop switch, exactly the same as in https://www.printables.com/model/651002-k1-extruder-filament-runout-sensor . If you purchased a kit with pre-soldered endstops with no swing levers, you don't have to solder new endstops - it is much easier to simply move swing levers from new endstops to the ones you have.
Despite the similarity to https://github.com/juliusjj25/ERCF-Pregate-Sensors, my design is NOT based on that, main difference being the filament switch used. However, the latches might be interchangeable :D
UPD: Initiql testing shows that the filament channel, despite being 2.4mm wide, requires calibration with a 2mm drill bit before installation.