Creality K1 Filament Drier Side Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Building instructions in description, designed for the Space Pi Filament Drier, but others can work with modification.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 26
- Makes
- 0
- Views
- 932
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Designed for the Creality Single Roll Space Pi Dehumidifier.
Shown model is printed in black Creality CR PETG
30% infill, 3 walls
I advise ABS, ASA or PETG at a minimum due to chamber temps or rather any high temp filament!
Bill of Materials ---------------------------
1 - M6x16 mm Machine Screw
2 - M6x12 mm Machine Screws
3 - M6 Machine Screw Nuts
2 - M6 Washers
Optional : Creality included 3M thin foam to reduce vibrations where connected.
Building Instructions -----------------------
1. Print the K1-Space-Pi-Inner Mounting Bracket
2. Press the two M6 Machine Screw Nuts into the print with a pliers.
3. Result should look the same as below
4. Drill two holes roughly 6.5 mm in diameter, 80 mm apart from center as shown below.
and choose a place for a third hole along the upper vertical area, (image with upper hole shown on step 5.)
2. Place masking take where the Filament Drier Aligns with the side of the printer and mark the holes in the drier onto the tape.
The left image shows the lower two holes and the right shows the upper hole.
I positioned the holes parallel (centered) with the fan mounting screws for the side fan. The z axis/ bed won’t interfere there.
5. Optional: Add the 3M thin foam tape onto the side of the drier to reduce vibrations.
6. Yay, you're done! If everything is correct it should look like the images below!
