Closet Door Pull 2-1/8 Router Jig
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple jig for a Makita trim router to cut out a recess for a flush closet door pull.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 7
- Makes
- 0
- Views
- 69
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Public Domain
Print one CenterLocator and one Cutout piece. 0.2mm layer height works great with PLA.
Place CenterLocator nested inside of the larger piece and locate the center hole to where you want to route out the spot for the door pull. Clamp to secure (with deep-throated clamps)
Route out hole carefully and slowly with a ¼" upcut endmill. I used a depth of about 5/16" for the hole.
Press fit the door pull in, no fasteners needed! This is designed for a standard 2-1/8" diameter door pull. General install location is 36" from the bottom of the door and 2-5/8" from the edge of the door.
Hope this is useful!