Pinocchio (HueForge)

Pinocchio (20x20 HueForge)

I found this Pinocchio picture on Pinterest, unfortunately without any further information about the original creator. It was printed with a 0.2 needle on a P1S, could possibly be adapted to a 0.4 needle, but I haven't tested that.

Print Instruction:
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm. The Model is 200x200mm in size. You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
    PLA eSun Matte Deep Black Transmission Distance: 0.1
    PLA Sunlu PLA+ 2 Red Transmission Distance: 6
    PLA BambuLab Matte Marine Blue Transmission Distance: 0.5
    PLA eSun PLA+ Yellow Transmission Distance: 6
    PLA BambuLab Basic Jade White Transmission Distance: 5
 

Swap Instructions:
    Start with Matte Deep Black
    At layer #10 (0.52mm) swap to PLA+ 2 Red
    At layer #15 (0.72mm) swap to Marine Blue
    At layer #19 (0.88mm) swap to PLA+ Yellow
    At layer #34 (1.48mm) swap to Jade White for the rest.
 

You can go with different filaments, but make sure that the TD is close to them.

For users with only one AMS:

Change the black filament to white when it's done and tell the slicer to change to black again at layer 34 (with the white filament loaded, ofcorse)