Secure Wall Mount for the Lego Endurance 10335

Overview

• This wall mount is keyed for the stand that comes with the Lego set, making sure that the ship cannot move side to side.

Printing

• This is a tight fit but works well on a 180x180mm build plate
• Both mounts are NOT identical, they are mirrored and that has to be done in the slicer
• Minimal supports are needed for the overhangs, the holes print fine without any

Mounting

• Mounting can be a little tricky but not impossible
• I would recommend first getting one screw on one side onto the wall and making sure it’s level before putting in the second screw
• Then insert the Lego stand into both of the printed brackets (one bracket should be loose while the other is securely mounted)
• Using a level and/or a straight edge, mount the loose bracket at the same height as the previous one.

Notes

• The fit for the Lego stand into the bracket is very tight and makes it difficult for the Lego stand to lift out. The model has holes on the bottom to allow the stand to be pushed out preventing anything from getting stuck.
• Feel free to request changes or ask for clarification on anything! I will see what I can do to help.