1 / 3
CAT DANCER HANDLE
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial
My cat loves the “Cat Dancer” toy but the handle isn't that great.
Hardware Needed:
Four M3x10 Screws
Four M3 Nuts
Has a groove down the handle that you can slot the wire into for storage.
This is a 2-piece handle that clamps around the original wire. You will need to remove the paper handle on the original. There is a cavity built into the handle to accommodate the old wire end.
-Print in supplied orientation.
-No supports needed.
-You may need a BRIM to keep the part from falling over during printing.