1 / 2
Stream Deck Multifunction Arm Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Share Alike
Nice and simple - a case for your Mk. 1 Stream Deck for use with @RostaP's multifunction arm system.
Printing
Print one of each.
- stream deck case: Place this on its bottom. No supports are needed here. After printing, tap the four holes on the top for M3 (you may be able to self-tap these with screws).
- stream deck lid: Place this on its top - use a bottom layer pattern you like. Just clean out the bridged M3 counterbores.
- stream deck case padding: This goes between your Stream Deck and the case. Print this in your favorite flexible filament. I recommend that only your first layer is solid, and use a sparse gyroid infill to give a bit of cushioning inside. No perimeters, no solid top layers. If you don't have a flexible filament, you may be able to get away with only printing the main section in a solid filament.