1 / 5
Amateur Radio Wire or Rope Winder — image 1
1 / 5

Amateur Radio Wire or Rope Winder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I'm developing a lightweight, compact winder for antenna wires and paracord guy lines.

Rating
0 / 5
Likes
6
Downloads
50
Makes
0
Views
308
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial

Having printed many of the wire winders available, I always found one or two things about each one that I didn't like - too big, too bulky, difficult to wind, doesn't self-deploy very well, tie-wraps getting in the way, etc.

I've developed this winder with a goal to integrate the features I am looking for in a packable, lightweight, compact, and easy-to-print design which I will continue to develop over time. As-designed, it will easily hold enough wire for a 40M EFHW (~66 Feet) and will also hold 125' of 90/1.18mm Paracord or well over 200' of braided 100-lb test fishing line.

The end loops are designed to allow the user to tie off the line by inserting the line through the loop and then pulling it over the loop, which secures the line and prevents further unwinding. A standard s-biner will also fit in the loops to allow a variety of attachment mechanisms. The center loop is intended to be the central pivot point when unwinding with minimal effort required - no more shaking the winder up and down. A great companion print is the S-Clip by K6ARK (I like to use the standard clip printed at 110% scale):

https://www.printables.com/model/402834-s-clip-s-biner

The model is easily scaled to meet your needs - here are my suggested sizes based on over a year of use in the field:

Size/Scaling

X

Y

Z

Ultra-Portable (QRP)

80

80

100

Standard

100

100

120

Super Capacity (QRO)

130

130

130

Here are my suggested printing characteristics:

Filament: PCTG, PETG or ASA (Not PLA)
Wall Loops: 5
Top Shell: 5
Bottom Shell: 5
Infill: 30% seems to be ideal.
Infill Pattern: Gyroid
Brim: Not Required unless you have bad adhesion issues - I use Bed Weld
Supports: Not Required
 

Tags