PCB Klicky for Sovol SV08

These parts were heavily either heavily inspired or directly taken from the whopping voron project.

To attach you will need:

• 2 m3 heat set inserts
• 2 m3x20mm cap head bolts
• 2 m3x8mm cap head bolt
• 2 m3 t-nuts
• 1 m2x2 heatset insert or superglue
• A pcb klicky kit ( I'm using the BTT kit)
• JST 1.25mm Connector kit (I highly recommend getting one with some precrimped wires)

Directions:

1.  Install m3 heat set inserts into frame_mount
2. Install m2 heat set insert into Probe Dock (or just glue a magnet in)
3. install 6 m2x4 heat inserts from kit into toolhead_mount and pcb_klicky
4. Attach kit magnets with screws
5. build your wire harness.  One side will use JST 1.25mm connections, the other will use the pins in the kit (JST-XH 2.54mm in case you screw up the crimping)
6. Attach the toolhead mount to the SV08 carriage using the existing screws from the inducive sensor and the bolt just under the toolhead magnet
7. Attach the Probe Dock to the frame_mount with m3x20 bolts.
8. Attach the frame_mount to the back gantry using the 8mm m3 and t-nuts

The toolhead shroud will not longer fit.  Before this modification, I was using the mini-light house cover and I just dremeled off the pieces that were interferring with the toolhead_mount.

My klipper macros are a bit of a mess right now, they work, but there is a lot of redundant moves.  If there is interest, I'll post them once they are cleaned up.