Celtic Knot (Triquetra Trinity Knot) notebook cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Design for a thin plate to cover a notebook featuring Celtic trinity knot triquetra.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 23
- Makes
- 0
- Views
- 270
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
This is a design for a 1.2mm thin plate intended to be glued onto the cover of a notebook. I wanted a simple design for the corners and a Celtic knot was easy enough to model (though a lesson in designing things like this in Fusion 360). In any case, it came out about as good as I could expect.
The corner designs are all done as negative relief (the art sits below the surface instead of being raised up). I think I could do a raised version if you want one… send a message on this model if you want one.
Printing notes:
- Nozzle: designed originally for my standard .4mm nozzle.
- Layer Height: I used .2mm layer heights
- Wall Count: I printed with wall count of 1.
- Line Directions: check the line directions to make sure the print lines are going in the desired direction (a lower layer will be visible)
Post-Processing:
- I went over the model LIGHTLY with some 150 grit sandpaper WITH THE GRAIN to remove little peaks caused by z-hops/ seams on the top layer.
- I still need to glue it to the notebook, but that should be easy enough.