1 / 1
Garden Spike
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Garden Spikes
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 52
- Makes
- 0
- Views
- 315
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
My spikes are a remix of https://www.printables.com/model/438967-landscaping-spike by @sclem
I’m using PLA because I want to see how well it holds up underground over time. PETG would probably be stronger and less likely to snap.
Updates
March 15/25 - Finally had a chance to test these Garden Spikes out. I broke a few of them so I’m going to change some of the printer settings and try again.
August 17/25 - Added a 3-barb Garden Spike.
Printer Settings
PrusaSlicer 2.9
Layer Height - .2
Perimeters – 6
Minimum Shell Thickness
- Top - 4mm
- Bottom – 4mm
Fill Angle - 90
Filament used in the picture
Printed Solid PLA Jessie Transition Roll