Peg Board wire holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holds spools of wire to a pegboard. Prints best with supports Wooden dowels: I use barbecue skewers or chopsticks.
- Rating
- 5 / 5
- Likes
- 36
- Downloads
- 117
- Makes
- 1
- Views
- 1,292
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
Holds spools of wire to a pegboard.
Prints best with supports
Wooden dowels:
I use barbecue skewers or chopsticks. Any stick smaller than 5/16 inch (9mm) diameter should work.
Pegboard attachment points:
For most strength, print with the 'side' down.
Based on the pegboard holders from "Make Anything's" youtube video
Print instructions
Category: Tool Holders & Boxes Print Settings
Printer Brand: Prusa
Printer: i3 MK2S
Rafts: No
Supports: Yes
Infill: light (15%)
Notes:
Draft - 0.3mm
Infill - Light (15%)
Supports - Yes
You could print slower and with more infill, but these settings are plenty strong. Took about 45 minutes to print each part.