Battery Extension for VFC PDW Stock
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Extension for the VFC PDW Stock that allow the use of larger batteries like many 1300mAh 3S brick types.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 43
- Makes
- 0
- Views
- 509
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
There's already a BEU (Battery Extension Unit) on the market for the PDW stock but it attaches on the inside of the metal piece that is attached to the gun, this effectively reduce the maximum possible width of the battery. Therefore I designed this one that attach on the outside instead, allowing for larger batteries to fit.
Print settings
Please refer to the slicer image and 3MF file for print orientation.
You want to use a material that has good layer adhesion and ideally is slightly flexible, not brittle, so the two “hooks” that attach to the metal piece of the stock won't break off.
I printed this in PBT+GF but many other types of filament should work well.
Depending on the tolerances of your printer the end cap may be a bit too tight, if so use a knife or sand paper to gently scrape off some of the edge for a looser fit. In my case that was not necessary.
Battery space
It should fit batteries up to around 95x38x25mm.
If you want a longer version please let me know and I'll add it.