Simplified Headphone stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple lightweight headphone stand made of three parts. Legs, rubber feeds (TPU) and a clips.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 4
- Makes
- 0
- Views
- 32
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Share Alike
This design contains three parts:
A Leg, a join-clips and a rubber feed.
Instructions:
You will need four legs, Two or three join-clips and eventual four rubber feeds. Assemble the parts by clicking the legs into the join-clips and put the rubber-feeds on the lover part of the legs. Can if not in use be made flat and stored e.g. in a draw.
Legs:
The legs shall be printed laying on the bed to get the highest strength. Some support might be required to get a good result.
Material: PLA, PETG, ABS etc.
Layer height: 0.1-0.2mm
Nozzle size: 0.4mm
Perimeters: 3
Infill: 5-15%
Support: Recommended.
Join-clips:
Material: Material: PLA, PETG, ABS etc. I have used PETG
Layer height: 0.2mm
Nozzle size: 0.4mm
Perimeters: 3
Infill: 5-15%
Support: Not required
Rubber feeds: Do not use infill. Might be difficult to mount if not hollow.
Material: Material: TPU A95
Layer height: 0.2mm
Nozzle size: 0.4mm
Perimeters: 2
Infill: 0%
Support: Not required