iMac 27" Stand with Storage
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An interlocking stand with storage compartments for the iMac 27" Monitor, raising it by 95mm.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 49
- Makes
- 0
- Views
- 321
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
iMac 27" Stand
& Interlocking Storage Compartments
Designed from scratch, this custom iMac stand features interlocking side storage compartments and a main compartment with cable management.
✅ Main Features:
- Centre Storage Compartment: Split into two halves with cable cut-outs for easy device connectivity.
- Lid Options:
- One with an integrated plinth for the iMac base.
- One with a separate plinth, allowing for multi-colour printing or filament swaps at the correct layer.
- Side Compartments: Mirror each other at a slight angle and connect to the main unit via male dovetails (supports required only for these dovetails).
- Easy Access: All compartments have open fronts.
- Secure Fit: The lid locks onto printed dowels (-0.2mm tolerance).
- Print Finish: I used a carbon fibre textured print sheet for a premium look on the lids.
✅ Fixing My Mistake - Chamfer Removal
My original design had chamfered edges (see main photo), but I had to remove them because the iMac stand base was wider than my first plinth design (oops!). After correcting my measurements, I adjusted the lid and plinth to fit perfectly.
✅ Dimensions & Print Settings:
- Base Size: 200mm x 200mm x 95mm (including lid & plinth).
- Filament & Strength:
- Main Compartment: PETG, 80% infill, 3 walls + extra alternate wall for added strength.
- Side Compartments: HS PLA (Hyper Speed), 30% infill, 2 walls + alternate extra wall.
- Extra Stability: I used sticky pads for added grip.
Affiliate link: Sticky Pads - Amazon
✅ Why This Design?
- I wanted a strong, practical, and modular solution for iMac users.
- I over-egged the infill % to handle the weight of the iMac—honestly, I could probably stand on it!
- Optional filament swaps let you customise the plinth for a personalised touch.
Would love to see your prints & remakes—enjoy building your ultimate iMac stand! 🚀
🍺 Support My Work 🍺
🍺 Drink Fund Link: If you’d like to support or simply by me a beer 🍺🍺🍺🥴, you can use the following PayPal Me link: