1 / 3
Holder for eye-occlusion-plaster / Halter für Augenokklusionspflaster / Schielpflaster / Augenpflaster — image 1
1 / 3

Holder for eye-occlusion-plaster / Halter für Augenokklusionspflaster / Schielpflaster / Augenpflaster

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A modular holder for the eyeplasters and a reminderboard.

Rating
0 / 5
Likes
1
Downloads
8
Makes
0
Views
48
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Ich benötigte einen Halter für die Augenpflaster meines Kindes.

Und Ich wusste nicht mehr, welches Auge an der Reihe ist.

System:

Die Boxen sind Modular druckbar und jeweils für 10 Pflaster ausgelegt. 
Das Schild und die untere Box sind als Abschluss nur einmal zu drucken.

 

Druck:

Drucke die Boxen auf der Rückseite mit Stützstrukturen um die Keilschiene präzise zu drucken. 0,2mm Layerhöhe ist präzise genug.

Wenn du den Magnet sichern möchtest, musst du im Slicer ein Loch in das Schild einbringen.

Drucke das Schild mit einem Stop um die Magnete in die Augen einzulegen oder mit Sekundenkleber einzukleben (5x2mm oder 5,5x2mm).

Achte hierbei auf die Ausrichtung, die Orientierung der Pole muss in die selbe Richtung zeigen.

 

Zusammenbau:

Stecke alle Module ineinander und verklebe sie bei Bedarf.

Klebe in das Pflaster den Magnet so ein, dass die Polarität auf dem Schild haftet.

Wenn die das Seil verwenden willst, Klebe dieses in das Loch ein und an das Pflaster.

 

Befestigung an der Wand/ Schrank:

Ich habe das System mit Heißkleber an der Wand befestigt, dieser darf allerdings beim Aufkleben nicht mehr zu warm sein.

Doppelseitiges Klebeband sollte auf glatten Flächen auch funktionieren.

 

______________________________________________________________________________________________________

 

I needed a holder for my child's eye patches.

And I no longer knew which eye it was turn to look at.

System:

The boxes are modular, printable and each designed for 10 plasters. 
The sign and the bottom box only need to be printed once.

 

Pressure:

Print the boxes on the back with support structures to print the wedge rail precisely. 0.2mm layer height is precise enough.

If you want to secure the magnet, you need to make a hole in the shield in the slicer.

Print the sign with a stop to insert the magnets into the eyes or glue them with superglue (5x2mm or 5.5x2mm).

Pay attention to the alignment, the orientation of the poles must point in the same direction.

 

Assembly:

Put all the modules together and glue them together if necessary.

Glue the magnet into the patch so that the polarity sticks to the sign.

If you want to use the rope, stick it into the hole and onto the patch.

 

Attachment to the wall/cupboard:

I attached the system to the wall with hot glue, but it shouldn't be too warm when sticking it on.

Double-sided tape should also work on smooth surfaces.

Tags