Ant Nest - Mesh Humidity System - Ant Mesh Nest
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A small ant nest being hydrated via a mesh and a tray full of water. Not suited for founding colonies.
- Rating
- 0 / 5
- Likes
- 24
- Downloads
- 180
- Makes
- 1
- Views
- 1,206
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
hello!!! i made this ant nest, it is totally not a carbon copy of esthetic ants mesh nest :sob:
pls support esthetic ants visit his shop and take a lookie
Hydrate the nest every 3 days for species like lasius, and hydrate every week for camponotus species.
The nest is 82mm, 57mm, 27mm (Width,Length,Height) including tray.
to make this nest you need:
3d printer and filament (obviously)
2mm thick acrylic
4 small screws
you also need to drill 4 holes in the glass so make sure you have a tool for that
Print guide:
25% infill or higher (to minimize light bleeding through the walls)
0.2 layer height or lower
no supports needed
How to print the mesh:
Line up the 2 small squares on the Mesh nest and Mesh models
And then go into per model settings, and change to these settings
(note that infill pattern is called “rectilinear” on prusaslicer/bambu studio)
Post print:
Cut some acrylic to size and screw it on
Put some cotton or sand into the watering tray:
And you're done!!!
if you decide to print this pls post makes i love to see them :folded_hands: