IKEA Platsa Pull-Out Tray
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Brackets to fit a full extension drawer slide into the IKEA Platsa cabinet
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 22
- Makes
- 1
- Views
- 650
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This 3D-printed bracket enables the mounting of SO-Tech/Junker 500 mm full extensions in your IKEA PLATSA cabinet, allowing you e. g. to install an AMS in a space-saving manner. The full extensions drawers are mounted onto the side walls using these brackets.
When using door brackets and standard brackets, the shelf board must be 527 mm wide. If only the standard brackets are used, a shelf board width of 537 mm is required.
Due to the structure (paper and pressboard) of the PLATSA cabinet's side panels, please be cautious with the load on the shelf, as its capacity is likely somewhat lower than that of the standard shelf.
Also note that if the cabinet is not anchored to the wall, extending the shelf may cause it to tip forward.
Required Parts
For a cabinet with a door:
- 3x Brackets for door side
- 6x Wood Screws 3,5 x 25 mm
- 3x Brackets for panel side
- 6x Wood Screws 3,5 x 40 mm
- 1x Shelf Board 527 mm wide
For an open cabinet:
- 6x Brackets for panel side
- 12x Wood Screws 3,5 x 25 mm
- 1x Shelf Board 537 mm wide
Changelog
| Date | Version | Type | Comment |
|---|---|---|---|
| 2025-03-03 | V1.0 | Release |