Teenage Engineering OP-Z to DJ Controller adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fun little contraption to take control of an encoder on the OP-Z using a compact disk. 😀
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 5
- Makes
- 0
- Views
- 297
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution
I started getting interested in DJing, but didn't want to invest into a proper controller right away, so I looked for something that I already own and could be (at least) temporarily repurposed to be able to experiment with. I realized that the OP-Z already had infinite encoders, which are kind of suitable for this purpose, but there were two issues:
- They are too small to be directly usable
- Their resolution is too low (about 32 ticks per revolution compared to the hundreds on entry level and even thousands on professional desks)
In order to overcome these limitations I decided to try and somehow upsize the rotating part, but instead of directly attaching it on top of the encoder I aimed for having some kind of a belt drive system, which would also allow for the introduction of a rotational multiplication factor, thus increasing the effective resolution.
In order to avoid wasting filament I looked for something round and thin and what gives, a CD happens to fit this description very well. 💿 (In case you're curious, all this time I've been setting the imaginary dance floor on 🔥 with various hits from an old Ubuntu 11.04 Natty Narwhal Alpha 3 installer. 😃)
To assemble the contraption, you'll also need a bearing with a 22 mm outer diameter and an 8 mm internal diameter, the same dimensions as those included for the Prusa Mini spool holder. In case you don't have those, a 20 pack of 608-ZZs can be had for less than €10. You'll also need a few LEGO Technic Axle Rods, but if you don't have them on hand, I'm fairly certain that many suitable alternatives can be found that you can print as well.
---
P.S. Source code for the MIXXX controller mapping and script is attached in the “Other files” section, I will try to clean it up and submit it as a contribution to be included in later releases. The current version assumes that the “module” track (#13) is selected, but you can override the MIDI values as you see fit.