1 / 4
3.5" HDD hard drive feet
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I needed some feet for my WD Red 3.5" HDD, so I quickly drew some up and printed them.
- Rating
- 5 / 5
- Likes
- 26
- Downloads
- 226
- Makes
- 3
- Views
- 1,171
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
I needed some feet for a 3.5" WD Red hard drive and quickly designed some in Fusion360.
No supports needed! Lay flat on the bottom side where the hole is (see last image).
The hole was designed with the following technique and prints great as is (no supports needed!): https://hackaday.com/2020/05/17/look-ma-no-support-for-my-floating-holes/
You'll need two classic #6-32 UNC “computer screws”.