kids trike wall mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
storage solution to keep a radio flyer or similar tricycle off the floor
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 23
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
a simple mount to hold the front tire of a kids trike and hang if off a wall. The mount should be printed as shown in the image of cura slicer included for strongest layers, there is also a hole for a 50-55mm M3 screw on both sides of the mount to reinforce the layer lines from de lamination along their weak plane under load. These screws are optional.
this model also includes 2 printed washers to further reinforce the layer lines where the mount clamps to the wall. These parts should be printed flat , with the below settings they should print solid, adjust print settings so there's no voids in the washers to compress.
Printed in PETG, 6 walls, 35% gyroid infill, 12 bottoms and tops
lag screws in the images are imported from McMaster Carr and not my work.