Candy / Hoover H-Free 100 Cordless Vacuum Motorized Agitator Brush GT2 Pulley for models HF122GPT011, HF122RH011
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A friend brought me a broken motorized brush attachment for a Hoover H-100 cordless vacuum. Turns out the metal drive…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 38
- Makes
- 0
- Views
- 162
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
A friend brought me a broken motorized brush attachment for a Hoover H-100 cordless vacuum. Turns out the metal drive shaft melted out of the drive pulley for the motorized agitator brush b/c of long hairs getting entangled in the brush and drive mechanism, stopping it from moving and generating a lot of friction heat.
There are no spare parts available from the manufacturer or 3rd parties. You can only buy the INcomplete motorized brush attachment for 50-60€, most offers not including the brush itself and 2 rollers on the back of the attachment (so you have to save these things from the old part). The whole vacuum with all attachments can be bought for about 110€ new.
The original pulley is made from POM directly molded onto a metal shaft, it uses a rather narrow GT2 belt. With the center melted out and POM being difficult to glue to just about everything else, I decided to try to make a new pulley adapting droftarts' very nice OpenSCAD pulley generator program and it worked out on the first (well actually 4th) try.
The new pulley was made from (recycled) Silk PLA+ from JAYO with 0.2mm layers, 4 walls and 15% gyroid infill.
The pulley axle dimensions were chosen to get a tight press-fit of the original driveshaft into the new pulley using a small vise without having to resort to heat or glue.
Since the whole thing came to me a little 'pre-melted' it may be you have to change some of the dimensions to get the part to fit on a less compromised drive mechanism. The Hoover H-100 specific dimensions start after line 223 in the OpenSCAD file. I suspect especially "hub_height_z" might have to be made a little smaller when all other parts of the drive mechanism are still in an unaltered state.
Until now everything seems to hold up well, and if the pulley breaks again it can easily be reproduced in PETG or ABS.
But, since some other plastic parts of the brush drive already took a beating because of the friction-generated overheating I'd rather have the new PLA pulley break before something much harder to reproduce fails.
Print Settings
Printer Brand:
Sovol 3D
Printer:
Sovol SV06
No
Supports:
No
0.2
Infill:
15
Notes:
Flip the pulley 180° before printing (hollow side up). Supports should not be needed, a brim may be helpful depending on your printer. At least 4 walls and 15% (gyroid) infill are recommended for press-fit stability.
Category: Replacement Parts
