Arendo mixer, stronger and thicker lid
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€10.39 – €12.70 net (excluding VAT)
For file: mixer_lid-lid_242.0g_7h38m_0.4n_0.25mm_PETG_MK4S.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €11.54 excluding VAT (range midpoint).
- Weight reported by the author
- 242 g
- Print time reported by the author
- 7.64 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
For Arendo 2kw mixer: the lid is not strong enough for my usage, so I printed one that is 6+mm thick everywhere
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 24
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- GNU General Public License v2.0
Also check out this chamber reinforcement :)
Print settings
- material: PETG, also enable brim for the lid only and set to brim_width=10mm, brim_type=inner+outer
- lid: 9 perimeters (to make it 100% solid along the top sloped part)
- lid's lid: 99 perimeters (to add to only one model: right click, add settings, layers&perimeters) also to make it fully solid
- supports: only for lid, “paint-on” only needed for the outside
- 1.02 extrusion multiplier: surface will look a bit worse but layer adhesion and general strength should ++
Assembly: Use 3pcs M3 screws, M3x10 or M3x12, even longer works, and screw lid's lid to lid. I recommend to do that only once, as the screws will bite their own thread, which is intended as a permanent mount: do not unscrew them multiple times.
If you want it food safe:
- Additionally, use glue before screwing lid+lid's lid it together
- Use stainless steel screws
- Paint the finished lid with food safe epoxy, probably 2 layers (24h curing inbetween) on the inside just to be sure an impact from inside the mixer doesn't simply chip off the resin
Final step: transfer the rubber seal from the original lid to this one
I use this mixer for grinding plastic to recycle 3d prints and it has been working great even though it was not designed for that. Hence these reinforcement parts