Wood Clamp Quick Adjust 3/8 Size
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a quick adjust clamp. It uses a washer on an angle to provide the quick adjust.
- Rating
- 0 / 5
- Likes
- 27
- Downloads
- 151
- Makes
- 0
- Views
- 880
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial
This is a quick adjust clamp. It uses a washer on an angle to provide the quick adjust.
You will require
3/8 threaded rod any length
3 - 3/8 bolts
1 - 3/8 washer (outside diameter is about 1 inch)
2 - 5/16 washer (goes on the handle)
The 3/8 washer goes in the sliding clamp. The two 5/16 washers go between the handle and the stationary clamp. 2 nuts go on the end of the threaded rod. I used a hammer to damage the threads so that the nuts will stay in place. I then put the handle pointing up and put the threaded rod with the nuts on top and hit the rod with a hammer to drive the nuts and threaded rod into the handle. The nuts and threaded rod stay in place because of the 2 small tabs on the handle. The 3rd nut goes on top of the stationary clamp just to stop it from moving.
Print instructions
Category: 3D Printing