1 / 4
Commandante Grinder Lid and Handle Clip
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lid and Clip to securely attach the handle to the main body of the grinder.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 46
- Makes
- 0
- Views
- 420
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model consists of a Lid and a clip to attach the handle of the coffee-grinder to the side of it.
It is designed specifically to the commandante (as that is my hand grinder) but you are allowed to remix it to any other grinder out there.
Print Advice:
- The Lid is designed with a space for a small round magnet of 1mm height and a diameter of 5mm. I strongly advise you to print it upside down (hole for the magnet facing upwards, like in the provided gcode files) because otherwise you either end up with support you barely are able to remove good enough to fit the magnet or you end up with so much inconsistency in sagging filament that you cannot fit the magnet properly.
- The HandleClip is somewhat slim, I printed it with a brim, and hadn't any problems.
The modelling file includes some other variations I played with, but all of them weren't to my taste, ultimately. Just for your convenience I provided the stl and gcode for a closed lid.