Crafters Desktop Vise
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A novelty benchtop clamp-on vise. For light use only. Good for arts and craft type projects.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 13
- Makes
- 0
- Views
- 110
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
A novelty benchtop clamp-on vise. For light use only. Good for arts and craft type projects. Use it as a practical accent, display object, or light-duty decor piece.
Provided are a few options for the handles. For non-slip jaw surfaces print the grips using TPU and glue in place. PETG will make a stronger vise over PLA.
The vertical screw parts get glued (CA glue) together. Make sure to assemble the screw before gluing the griping parts in place. Also, be very careful not to get glue where not intended. A toothpick works well for getting glue into very small places.
The horizontal screw handle parts get assembled using a 5/32" x 1-1/4" long roll pin (purchased part).
Note that the horizontal and vertical screws are supplied alone (to print as you desire) and in a disposable support cone. This cone keeps the screws stabilized while printing. Simply discard the cone after printing.
The threaded areas should be printed at a low layer height. The whole project prints best with a
.4mm nozzle.