Wall wart ID and wire wrap helper
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Because a bin full of adapters equals quite a mess
- Rating
- 0 / 5
- Likes
- 26
- Downloads
- 52
- Makes
- 0
- Views
- 348
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Options for voltage identification: 3, 4, 5, 7.5, 8, 9, 10, 12, 15, 18, 19, 24, 48, 52
…or… AC, DC …or… BLANK
You can also print in different colors to identify different adapters
All .stl are now revision 2, which makes it fit even if there is a ground prong
Your choice to wedge the bare wires in-between the clamp or insert the barrel jack
Try wrapping different directions or over-wrapping the wire to end up with just the right length at the end.
Designed to hug the prongs securely, squeeze the barrel jack to prevent slipping out, and protect the prongs from entanglement with other adapters when thrown in a bin.
Suggest using PETG (only a 16min. print on 0.15mm setting, no supports, I don't need a brim)
Need a "Type C plug" version, commonly used in Europe, South America & Asia?
This guy made it: https://www.prusaprinters.org/prints/124355-wire-cap-for-europlug