Pint Holder for Ben & Jerry's Icecream
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ben & Jerry's ice-cream personal pint holder
- Rating
- 4.833 / 5
- Likes
- 101
- Downloads
- 671
- Makes
- 4
- Views
- 3,738
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Slip an ice cold pint of Ben & Jerry's in here and enjoy without cold hands or a wet lap.
Not in the mood for ice-cream? (What's wrong with you? Maybe a cup noodle? https://www.printables.com/model/1243757-cup-noodle-cup )
Inspired by https://makerworld.com/en/models/862850-ice-cream-pint-cozy-keep-your-hands-warm - I wanted to redesign a nicer (in my opinion) handle, remove the spoon holder, and add some tabs inside to prevent the pint from rotating as you scoop. This is sized specifically for this brand, but does hold other pints (though perhaps not as snugly)
I also love the fuzzy skin effect, and will add a 3mf so you can see the setting I used on the one in the photos. I think it looks nice with the fuzzy skin applied with a height modifier from (say) 4 to 105 (i.e. a bit above the bottom and below the top lip).
Printing tips:
See above for fuzzy skin. I found it better to draw in the inside seam so that it is not right on one of the tabs (where it was causing me extra stringing). I also bumped up the top walls to thicken the rim and prevent any pulling away at the edge. I use a pretty open infill for better insulation, e.g. 8% crosshatch.