1 / 10
Tronxy X1 E3D lite6 mount incorpoating fixings for supercooler fan dcts — image 1
1 / 10

Tronxy X1 E3D lite6 mount incorpoating fixings for supercooler fan dcts

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a mount for the Tronxy X1 (may also work for the X3) to fix the E3D lite6 hotend complete with fixings for the…

Rating
0 / 5
Likes
1
Downloads
7
Makes
0
Views
79
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

This is a mount for theTronxy X1 (may also work for the X3) to fix the E3D lite6 hotend complete with fixings for theSuper Cooler 30mm fan ducts.

Please note: the front clamp is asymetrical, please make sure you install it the correct way up.

All screws are M3 and self tap into the back section.

Print Settings

Printer:

TronXY X1

Rafts:

No

**Supports:**

No

Resolution:

0.15mm

**Infill:**

30%


Notes:

4 perimeters
3 top and bottom layers

Post-Printing

Step 1

Remove existing hot end from the X gantry support plate

Step 2

Attach the newly printed back plate to the X gantry support plate with 4 No. M3 x 12 screws

Step 3

Attach the Super Cooler part cooling fan ducts to the support posts using M3 x 12 screws (you can probably use shorter, but this is what I used).

Step 4

Assemble your E3D lite 6 hot end as per the E3D instructions, and push into the back support plate. It is a snug fit.

Step 5

Attach the front clamp to hold the hot end in position. Be careful, this is slightly asymmetric, There is a top and bottom. Make sure when installed the two top surfaces align, if not rotate 180 degrees.
Attach with 2 No. M3 x 20 screws.

Category: 3D Printer Parts

Tags