1 / 5
Qidi Plus 4 Mount for 10x35 mm Hotend Fan — image 1
1 / 5

Qidi Plus 4 Mount for 10x35 mm Hotend Fan

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replace the stock 10x25 hotend fan with a larger fan to increase the air flow on the heat break

Rating
0 / 5
Likes
3
Downloads
29
Makes
0
Views
386
Reviews
0

Updated at source:

Model information

License
Creative Commons — Public Domain

I upgraded the stock hotend cooling fan which is 10x30 to a 10x35 fan to improve cooling on the hotend heat break. I was getting a lot of issues tight filament buckling just before the hotend area and wanted to further cool the filament at this point. I had installed the shield to direct the flow more accurately on the heat break area but wanted more cooling effect. I looked at the 4020 upgrade but wanted to keep the existenting stock cover which the 3510 allows. It's a minor flow upgrade but it seems to have improved the cooling effect but I could not find any flow information on the fan (https://a.co/d/5gc4cRD) which is a 2-wire 24V Winsinn dual ball bearing brushless I got from Amazon as a pack of 5 for $17 so it matched the original specs perfectly. There is nothing special about the mount, just remove the old one and replace with this one after screwing in the fan and plug into the same socket as the old fan, no changes at all. Note from the picture that I could only fit 3 of the 4 screws on the fan due to space limitations and the 3rd bolt against the extruder assemble had to go in backward to fit properly. This has not completely eliminated filament buckling issues with soft filaments but it has improved it somewhat.

Tags