BAMF Shorta

This is BAMF Shorta, a remix of 44sunset's Blitz Shorta, which is in turn a remix of Zach Freedman's Blitz Saya. It is a molle mountable double-stack Talon Magazine carrier, good for tactical vests or anything else with molle webbing. My goal with this remix is to make the double stack Blitz Shorta more compact and quicker/easier to print, while preserving its best feature, the right and left offsets. The offsets allow you to squeeze additional magazines in the same amount of space without them interfering with one another. It is hard do describe, see picture below:

In the example you'd normally only be able to fit 3 mag holders without offsets, but you can fit another one using BAMF shorta (or blitz shorta). 

Hardware

• 1/8" or 3mm elastic shock cord
• A cord lock (optional, but nice for adjusting tension)

Printing

Everything is oriented for printing. These don't need anything special, I print mine in PETG, 0.20mm layer height, 4 walls, 20% gyroid infill, at 60mmps. Support and brims are unnecessary in my experience. Each BAMF requires one body, two grips, one divider, and a molle stick.

Assembly

1. Cut a length of shock cord around 32" long
2. Thread the shock cord through the top holes in the back, near the Molle stick holder. Keep both sides of the cord roughly equal
3. Sandwich the first mag holder, the mag divider, and the second mag holder inside the main body, and thread the shock cord though the holes on the top, and into the front of the body
4. Thread the shock cord down and out of the first segment on the front of the body, then cross it to the back of the body again. Work your way down in this manner until you reach the bottom of the mag holder. Be sure to thread the shock cord through the second set of holes on the mag grips and divider. 
5. Thread the shock cord into the holes on the bottom of the mag holder, secure with a cord lock if you want, or tie the cord together. Trim any excess cord you don't want, and singe the edges so it does not fray.