1 / 2
Starkvind Duct Adaptor
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adaptor to allow a dryer pipe to fit into an IKEA Starkvind Air Purifier
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 10
- Makes
- 0
- Views
- 301
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
Adaptor to allow a dryer pipe to fit into an IKEA Starkvind Air Purifier, I use it to attach my 3D printers rear exhaust vent to the air purifer.
Simple to install, just open the front panel, insert the adaptor and clamp in place with the front panel. Then use a jubilie clip to attach the pipe and attach to whatever you need.
Piping used was 4 inches/100 mm.
Printing Recommendations::
- PETG (so it can flex a little)
- 20% infill
- At least 3 walls
- No supports